Home / Boards / Arduino

Arduino boards

5 V classics with the biggest tutorial library.

An Arduino Uno-style board showing the digital pins along the top and the power and analogue pins along the bottom

Arduino boards are where most people start. The Uno has been the standard beginner board for well over a decade, so almost every kit, shield and tutorial is written for it. You program them in Arduino C++ from the free Arduino IDE, and the code runs on its own the moment the board gets power: no operating system, no boot time.

The main models compared

Uno R3Uno R4 Minima / WiFiMega 2560 Rev3
ChipATmega328P, 8-bit AVRRenesas RA4M1, 32-bit Arm Cortex-M4ATmega2560, 8-bit AVR
Clock16 MHz48 MHz16 MHz
Flash / RAM32 KB / 2 KB256 KB / 32 KB256 KB / 8 KB
EEPROM1 KB8 KB (data flash)4 KB
Logic level5 V5 V5 V
Digital pins14 (6 with PWM)1454 (15 with PWM)
Analogue inputs6 (10-bit)6 (up to 14-bit), plus a 12-bit DAC16 (10-bit)
WirelessNoneNone on the Minima. The WiFi model adds an ESP32-S3 for Wi-Fi and BluetoothNone
USBUSB-BUSB-CUSB-B

Figures from the manufacturer's documentation, listed under Sources.

Which one should you get?

Get an Uno R4 if you're starting today. It runs the same tutorials as the R3 with far more memory, and the WiFi version saves adding a separate wireless board. Get a Mega 2560 when you run out of pins, for example on 3D printers, big LED projects or anything with several serial devices, because it has four hardware UARTs. The Uno R3 is still everywhere and perfectly good for learning.

Things that catch people out

  • Per-pin current is lower on the R4. Arduino rates the Uno R4's pins at 8 mA each, compared with 20 mA on the R3. A standard LED with a 220 Ω resistor is fine on an R3 but asks for more than an R4 pin should give. Use a bigger resistor or a transistor. Our LED resistor calculator does the sums.
  • 5 V logic. Unos and the Mega talk at 5 V. Many modern sensors are 3.3 V only, so check before you connect, and use a level shifter where needed.
  • Pins 0 and 1 are the serial port. On the Uno R3 and Mega they're shared with the USB connection, so anything wired to them can stop uploads working.
  • VIN isn't a magic power input. The on-board regulator turns extra voltage into heat. Running motors or long LED strips from the board's 5 V pin is a common way to overload it.

Sources