Home / Boards / Raspberry Pi Pico

Raspberry Pi Pico boards

Cheap, fast microcontrollers that run MicroPython.

A Raspberry Pi Pico and a Pico 2 side by side

The Pico is Raspberry Pi's microcontroller board. Unlike a Raspberry Pi, it doesn't run Linux: it runs one program, starts instantly and uses very little power. It's the easiest way into MicroPython, and it's cheap enough to leave built into a project.

The main models compared

Pico / Pico WPico 2 / Pico 2 W
ChipRP2040, dual Arm Cortex-M0+RP2350, dual Arm Cortex-M33 or dual RISC-V (your choice)
Clock133 MHz150 MHz
Flash / RAM2 MB / 264 KB4 MB / 520 KB
GPIO26 on the header, 3.3 V26 on the header, 3.3 V
5 V tolerant?NoDigital pins only, and only while powered. Never the ADC pins
Analogue inputs3 (12-bit)3 (12-bit)
Wireless (W models)2.4 GHz Wi-Fi and Bluetooth (Infineon CYW43439)2.4 GHz Wi-Fi and Bluetooth (Infineon CYW43439)
Power inputVSYS 1.8 to 5.5 V, or USBVSYS 1.8 to 5.5 V, or USB

Figures from the manufacturer's documentation, listed under Sources.

Which one should you get?

Get a Pico 2 W unless you have a reason not to. It has twice the memory of the original for little extra money, and Wi-Fi saves you a board later. The original Pico and Pico W are still fine for learning, and all four share the same pin layout, so our projects work on any of them. The "H" versions come with headers already soldered.

Things that catch people out

  • Wrong firmware is the most common problem. Each model needs its own MicroPython file. Pico W firmware is different from Pico firmware, and Pico 2 needs RP2350 firmware.
  • The LED pin differs. On W models the on-board LED is wired to the wireless chip, not GP25. Use Pin("LED") in MicroPython and it works on every model.
  • Small drive currents. Pins default to 4 mA drive, settable up to 12 mA. Switch motors, relays and bright LEDs with a transistor.
  • 3V3(OUT) is for small loads. Raspberry Pi suggests keeping it under about 300 mA.

Sources