Home / Tools / SMD resistor code calculator

SMD resistor code calculator

Surface-mount resistors use number codes instead of colour bands. Type the code to get the resistance.

  • Electronics tool
  • Runs in your browser
  • Tested 19 November 2026
  • Sources
For example 103, 4702, 4R7, R010 or 01C.

The three main systems

Three digits, usually on 5 % parts: the first two digits are the value and the third is the number of zeros. 103 = 10 followed by 3 zeros = 10,000 Ω = 10 kΩ. 470 = 47 Ω.

Four digits, usually on 1 % parts: the first three are the value and the fourth is the number of zeros. 1002 = 100 followed by 2 zeros = 10 kΩ. 4991 = 4.99 kΩ.

R for the decimal point on low values: 4R7 = 4.7 Ω, R100 = 0.1 Ω. Current-sense resistors often use this.

A resistor marked 0 or 000 is a zero-ohm link, used as a jumper.

EIA-96 codes

1 % resistors in small packages such as 0603 don't have room for four digits, so they use two digits and a letter. The two digits are an index into the standard E96 series of values, and the letter is a multiplier. 01C is the first E96 value, 100, times 100 = 10 kΩ. 68X is the 68th value, 499, times 0.1 = 49.9 Ω.

LetterMultiply byLetterMultiply by
Z0.001B or H10
Y or R0.01C100
X or S0.1D1,000
A1E10,000
F100,000

When a code doesn't make sense

Some makers use their own marking schemes, and tiny 0402 and 0201 parts usually aren't marked at all. If a value looks wrong, measure it out of circuit with a multimeter, because other parts on the board can upset an in-circuit reading.

Sources

Where the formulas and figures on this page come from. We test every tool against worked examples from these before publishing.

  • IEC 60062: Marking codes for resistors and capacitors (paid standard, not online)