Home / Tools / Star–delta (Y–Δ) converter

Star–delta (Y–Δ) converter

Convert three resistances or impedances connected in star (Y) to the equivalent delta (Δ), or the other way round. Handy for simplifying bridge circuits and balanced three-phase loads.

  • Electrical tool
  • Runs in your browser
  • Tested 19 November 2026
  • Sources
Between terminals a and b.

The formulas

Label the three terminals a, b and c. In delta, Rab, Rbc and Rca connect the pairs of terminals. In star, Ra, Rb and Rc run from each terminal to a common centre point.

  • Delta to star: each star resistor is the product of the two delta resistors touching that terminal, divided by the sum of all three. Ra = Rab Rca / (Rab + Rbc + Rca), and the same pattern for Rb and Rc.
  • Star to delta: each delta resistor is the sum of the pairwise products, divided by the star resistor on the opposite terminal. Rab = (RaRb + RbRc + RcRa) / Rc, and so on.

The two networks are equivalent from outside: the resistance measured between any two terminals, with the third left open, is the same. The tool shows those three values so you can check.

Worked example. A delta of Rab = 12 Ω, Rbc = 6 Ω and Rca = 18 Ω (the bridge example from All About Circuits) becomes a star of 6 Ω, 2 Ω and 3 Ω. Between a and b, both measure 8 Ω.

Balanced loads

When all three are equal, the conversion is simply RY = RΔ / 3. This is why a three-phase heater or motor winding connected in delta draws three times the line current it would in star on the same supply, which is the idea behind star–delta motor starting. The same formulas work with complex impedances for AC, but this tool handles resistances (or impedances with the same phase angle).

Sources

Where the formulas and figures on this page come from. We test every tool against worked examples from these before publishing.