Home / Buying guides

Buying guide: phase rotation testers

A phase rotation tester connected to L1, L2 and L3, showing clockwise rotation
Beginner
How we wrote this: we haven't tested these instruments hands-on for this guide. Every figure comes from the manufacturer's own specifications, linked at the end. Models get discontinued and replaced, so check the current version before you buy. We don't earn anything if you buy one.

In a three-phase supply, the three phases reach their peaks in a fixed order. Swap any two and a three-phase motor runs backwards. A phase rotation tester shows the sequence, so you can check it before connecting a motor, pump or conveyor, or after work on a supply. It's much safer than finding out by bumping the motor.

Contact or non-contact

  • Contact testers connect to the three phases with probes or clips. They're simple and cheap, and many need no battery because they're powered by the supply under test. You still have to touch live terminals, so use them only where you can do so safely.
  • Non-contact testers clip around the insulated cables and sense the phase through the insulation. No metal touches a live part, which is safer and quicker, especially on cables you can't easily get a probe onto.

What to look for

  • Voltage range that covers your systems. In the UK, a three-phase supply is 400 V between lines and 230 V to earth.
  • Open-phase indication, so a missing phase isn't mistaken for a reversed one.
  • Motor rotation. Some testers can also show which way an unpowered motor will turn when you spin its shaft, or a running motor's direction without contact.
  • Safety rating appropriate to where you'll use it, from CAT III at distribution boards to CAT IV at the origin.

Three testers compared

TesterTypeVoltage rangeSafety ratingPower
Fluke 9040Contact, with probes and clips40 to 700 V, 15 to 400 HzCAT III 600 V, CAT IV 300 VNo battery: powered from the circuit
Fluke 9062Contact, plus contactless motor rotationPhase display 120 to 400 V AC, 2 to 400 HzCAT III 300 VBattery
Hioki PD3259-50Non-contact sensors on the insulation90 to 520 V AC, 45 to 66 HzCAT IV, 600 V to earthFour AA batteries, about 5 hours

Fluke 9040

A straightforward contact tester. Its display shows all three phases and the direction of rotation, it works from 40 to 700 V, and it needs no battery. Its probes have an adjustable clamping range to suit industrial sockets.

Fluke 9062

Adds motor work to phase testing. As well as showing the supply's phase sequence, it can find the rotation direction of a running three-phase motor without contact, which helps when the shaft is hidden. Its CAT III 300 V rating means it's meant for use at equipment level, not at the origin of an installation.

Hioki PD3259-50

A non-contact tester whose three sensors clip around insulated cables from 6 to 30 mm across, with no exposed metal. It shows phase sequence and the three line-to-line and line-to-ground voltages together, and warns of reverse sequence with a red light and buzzer. Its CAT IV rating makes it suitable at the supply origin.

Most electricians carry a phase rotation tester alongside a multifunction tester and a clamp meter. Some MFTs include phase rotation testing, so check yours before buying a separate one.

Sources

The main references behind this guide. Numbers we worked out ourselves, such as the code outputs, come from running the code.