Home / Tools / Zener diode regulator calculator

Zener diode regulator calculator

Design a simple Zener diode voltage regulator: the series resistor, and the power the Zener and resistor need to handle across your input range.

  • Electronics tool
  • Runs in your browser
  • Tested 19 November 2026
  • Sources
Keeps the Zener regulating. 5 mA suits most small Zeners; check the datasheet's test current.

How to size the resistor

The series resistor has to pass the full load current plus a little for the Zener, even when the input is at its lowest. So:

R ≤ (VIN(min) − VZ) ÷ (ILOAD(max) + IZ(min))

The worst case for the Zener is the highest input with no load: all the current then goes through the Zener. PZ = VZ × (VIN(max) − VZ) ÷ R. The resistor's worst case is also the highest input: PR = (VIN(max) − VZ)² ÷ R.

Worked example. 9 to 12 V in, a 5.1 V Zener, 20 mA load and 5 mA minimum Zener current: R ≤ (9 − 5.1) ÷ 0.025 = 156 Ω, so use the next lower E24 value, 150 Ω. At 12 V with no load, the Zener takes (12 − 5.1) ÷ 150 = 46 mA, or 0.235 W. A 0.5 W Zener gives a safe margin. The resistor dissipates 0.32 W, so use a 0.5 W or larger resistor.

Things to know

  • Pick the next standard resistor below the maximum, not the nearest, or the regulator drops out at low input.
  • Derate: run the Zener at no more than about half its rated power, especially in a warm box.
  • Zener regulators waste power and don't regulate tightly. For more than a few tens of milliamps, use a linear regulator such as the LM317, or a switching regulator.

Sources

Where the formulas and figures on this page come from. We test every tool against worked examples from these before publishing.

  • Zener shunt regulator design, standard circuit theory (Ohm's law and P = VI)
  • IEC 60063: Preferred number series for resistors and capacitors (E24, E96; paid standard)