Home / Tools / Heatsink and junction temperature calculator

Heatsink and junction temperature calculator

Find the heatsink a linear regulator, MOSFET or transistor needs to keep its junction below its maximum temperature, or check how hot it will run with the heatsink you have.

  • Electronics tool
  • Runs in your browser
  • Tested 19 November 2026
  • Sources
Quiescent or ground-pin current, from the datasheet.
Inside an enclosure it's often 10 to 20 °C above the room.
From the datasheet. Many designers aim 10 to 25 °C lower.
From the datasheet.
About 0.1 to 1 with thermal paste or a pad.
To check the junction temperature with a heatsink you already have.

How heat flows

Heat flows from the hot silicon junction, through the package, through the thermal paste and into the heatsink, then into the air. Each step has a thermal resistance in °C per watt: how many degrees hotter one side is than the other for each watt flowing. They add up like resistors in series:

TJ = TA + P × (θJC + θCS + θSA)

Rearranged, the heatsink must be no worse than θSA = (TJ − TA) / P − θJC − θCS. Pick a heatsink with a θSA lower than the answer, which means a bigger heatsink.

Worked example. A 7805 regulator dropping 12 V to 5 V at 0.5 A dissipates (12 − 5) × 0.5 = 3.5 W, ignoring the small current the regulator uses itself. With 40 °C air, a 125 °C limit, θJC = 5 °C/W and 0.5 °C/W for the thermal pad, the heatsink must be better than (125 − 40) ÷ 3.5 − 5.5 = 18.8 °C/W.

Where the numbers come from

  • θJC is in the part's datasheet, usually in a thermal information table. Use the figure for the package you have.
  • θSA is in the heatsink's datasheet. It's usually given for natural convection with the fins vertical. A fan can cut it a lot.
  • Without a heatsink, use the datasheet's θJA instead of the whole sum. Be careful: θJA is measured on a specific test board, so a part on a small board or in a box will run hotter.

Better than a bigger heatsink

A linear regulator throws away the voltage difference as heat. If the dissipation is more than a watt or two, a buck converter is usually the better fix, since a typical one is 85 to 95 % efficient. Our guide to powering projects safely compares the options.

Sources

Where the formulas and figures on this page come from. We test every tool against worked examples from these before publishing.

  • JEDEC JESD51 series: definitions of junction-to-case and junction-to-ambient thermal resistance