Home / Tools / PCB trace width calculator

PCB trace width calculator

Find the minimum width of a copper track for the current it carries, using the IPC-2221 formula, plus its resistance and voltage drop.

  • Electronics tool
  • Runs in your browser
  • Tested 19 November 2026
  • Sources
10 °C is a common, conservative choice.
For resistance and voltage drop.

The formula

IPC-2221, the generic standard for printed board design, relates current to the cross-section of the copper and how much it is allowed to heat up:

I = k × ΔT0.44 × A0.725

Here I is in amps, ΔT is the temperature rise in °C, A is the cross-sectional area in square mils, and k is 0.048 for outer layers and 0.024 for inner layers. Inner layers get half the current for the same area because they can't shed heat to the air. The calculator solves for A, then divides by the copper thickness to get the width. One ounce of copper per square foot is 1.378 mils, or 35 µm, thick.

Worked example. 1 A on an outer layer of 1 oz copper with a 10 °C rise needs about 16 mil² of copper, which is a track about 12 mils, or 0.30 mm, wide.

How far to trust it

  • The formula is a curve fit to old test data. It's usually quoted as valid for up to about 35 A, widths up to 400 mils, and rises of 10 to 100 °C.
  • The newer IPC-2152 standard is based on more thorough testing. It shows IPC-2221 is very conservative for inner layers and depends on board thickness, nearby copper planes and other heat paths. For high-current or tightly packed designs, use IPC-2152 or your board maker's guidance.
  • Heat isn't the only limit. Check the voltage drop along a long track, and use wider tracks than the minimum wherever there's room. It costs nothing on a PCB.

The resistance uses copper's resistivity of 1.72 × 10−8 Ω·m at 20 °C, raised by 0.393 % per °C, and is worked out at 25 °C plus your temperature rise.

New to board design? Read Designing your first PCB.

Sources

Where the formulas and figures on this page come from. We test every tool against worked examples from these before publishing.

  • IPC-2221: Generic standard on printed board design (paid standard, not online)