Home / Tools / Buck converter calculator

Buck converter calculator

Size the power stage of a buck (step-down) switching regulator: duty cycle, inductor, peak current and output capacitor, using the method in Texas Instruments application note SLVA477.

  • Electronics tool
  • Runs in your browser
  • Tested 19 November 2026
  • Sources
Use the regulator datasheet's efficiency curve. 85 to 95 % is typical.
TI suggests 20 to 40 %.
To see the ripple and peak current it gives.

The equations

These come from Texas Instruments' application note Basic Calculation of a Buck Converter's Power Stage (SLVA477). The worst case for inductor ripple is the highest input voltage, so the tool uses that.

  • Duty cycle: D = VOUT ÷ (VIN × η)
  • Ripple current: ΔIL = 20 to 40 % of the output current
  • Inductor: L = VOUT × (VIN(max) − VOUT) ÷ (ΔIL × fS × VIN(max))
  • Peak current: IPK = IOUT + ΔIL ÷ 2
  • Output capacitor: COUT(min) = ΔIL ÷ (8 × fS × ΔVOUT), and ESR ≤ ΔVOUT ÷ ΔIL
Worked example. 10 to 14 V in, 5 V at 2 A, 500 kHz, 30 % ripple. ΔIL = 0.6 A. L = 5 × (14 − 5) ÷ (0.6 × 500,000 × 14) = 10.7 µH, The next standard value up is 12 µH. A 10 µH part gives 0.64 A of ripple (32 %), which is usually fine too: try it in the "your inductor" box. The inductor must not saturate below the peak current, 2.3 A plus margin. For 50 mV ripple, COUT ≥ 0.6 ÷ (8 × 500,000 × 0.05) = 3 µF, with ESR under 83 mΩ.

Things to know

  • The regulator datasheet wins. Most buck regulator chips give a recommended inductor range and output capacitors for stability. Use this tool to understand and check those numbers, not to overrule them.
  • Choose an inductor with a saturation current comfortably above the peak current, and an RMS rating above the output current.
  • Ceramic capacitors lose a lot of capacitance at their working DC voltage. A 10 µF 10 V part may give only 4 to 6 µF at 5 V. Check the manufacturer's DC-bias curve.
  • Layout matters as much as the values: keep the input capacitor, switch and diode loop tiny. See our PCB design guide.

Sources

Where the formulas and figures on this page come from. We test every tool against worked examples from these before publishing.