Home / Tools / RC, RL and LC filter calculator

RC, RL and LC filter calculator

Find the cut-off frequency of a simple RC, RL or LC filter, and the gain and phase at any frequency.

  • Electronics tool
  • Runs in your browser
  • Tested 19 November 2026
  • Sources
Use k, M, m, µ (or u), n and p, for example 4k7, 100n or 22u.
For LC: the load resistance across C. Leave blank for no load.
Use k, M, m, µ (or u), n and p, for example 4k7, 100n or 22u.
Use k, M, m, µ (or u), n and p, for example 4k7, 100n or 22u.
Gives the R for a target, keeping C (RC) or L (RL).

The formulas

  • RC filter: fc = 1 ÷ (2π R C)
  • RL filter: fc = R ÷ (2π L)
  • LC filter: f0 = 1 ÷ (2π √(L C)), with Q = Rload × √(C ÷ L)

At the cut-off frequency a first-order filter passes 70.7 % of the voltage (−3 dB), with a 45° phase shift. Beyond it, the output falls by 20 dB per decade (6 dB per octave). An LC filter is second order: it falls at 40 dB per decade, but it can peak near f0 if Q is above 0.707.

Worked example. R = 1 kΩ and C = 100 nF: fc = 1 ÷ (2π × 1,000 × 100 × 10⁻⁹) = 1.59 kHz. At 10 kHz an RC low-pass passes 15.7 % (−16.1 dB), with −81° of phase shift.

Which way round?

  • RC low-pass: R in series, C to ground, output across C.
  • RC high-pass: C in series, R to ground, output across R.
  • RL low-pass: L in series, R to ground. RL high-pass: R in series, L to ground.
  • LC low-pass: L in series, C to ground, with the load across C. This is the output filter of a buck converter.

Things to know

  • These assume an ideal source (zero output impedance) and, for RC and RL, no load. A load in parallel with the output changes the cut-off. Buffer the output with an op-amp if it matters.
  • An unloaded or lightly loaded LC filter has a high Q and can ring. Damping, such as a resistor or the capacitor's ESR, keeps it under control.
  • Real inductors have resistance and capacitors have ESR, so measured results will differ a little at the extremes.

Sources

Where the formulas and figures on this page come from. We test every tool against worked examples from these before publishing.

  • First- and second-order RC, RL and LC filter equations, standard circuit theory
  • First-order RC circuit equations, standard circuit theory