Home / Tools / Capacitor energy and discharge calculator

Capacitor energy and discharge calculator

Work out how much energy a charged capacitor holds, how long it takes to discharge through a resistor, and the bleeder resistor that brings it to a safe voltage in a set time.

  • Electrical tool
  • Runs in your browser
  • Tested 19 November 2026
  • Sources
Use k, M, m, µ (or u), n and p, for example 470u or 100k.
The voltage you want it below. 50 V is a common choice, but check the standard you're working to.
Use k, M, m, µ (or u), n and p, for example 470u or 100k.
To size a bleeder resistor.

The formulas

  • Stored energy: E = ½ C V², in joules.
  • Through a resistor R, the voltage falls exponentially: V(t) = V₀ e−t / RC. So the time to fall to a safe voltage Vs is t = RC × ln(V₀ / Vs).
  • Rearranged for a bleeder resistor that reaches Vs in time t: R = t / (C × ln(V₀ / Vs)).
  • The resistor's peak power is at the start: P = V₀² / R. Its average power is much lower, but it must also handle the voltage itself, so use a resistor or a chain of resistors rated for V₀.
Worked example. A 470 µF capacitor charged to 400 V stores ½ × 0.00047 × 400² = 37.6 J. Through 100 kΩ, the time constant is 47 s, and it takes 47 × ln(400 ÷ 50) = 97.7 s to fall below 50 V. To get below 50 V in 60 s, the bleeder needs to be 61.4 kΩ or less, dissipating 2.6 W at the start.

Staying safe

  • Even a few joules at a high voltage can give a dangerous shock. Always measure the voltage across the capacitor before touching it, even when a bleeder is fitted, because resistors can fail open.
  • Standards set their own limits for how fast equipment must discharge and to what voltage. Check the one that applies to your work.
  • Don't short a large charged capacitor with a screwdriver. The current can weld metal, throw sparks and damage the capacitor. Use a suitable resistor.

Sources

Where the formulas and figures on this page come from. We test every tool against worked examples from these before publishing.

  • First-order RC circuit equations, standard circuit theory